Retour au blog
Guides pratiques 2026-11-20 Sun Tanning Store 0 vues

Fuji 5135-5 Pressure Tube and Duck Bill Replacement Guide

Fuji 5135-5 Pressure Tube and Duck Bill Replacement Guide

Learn how to replace the Fuji 5135-5 pressure tube and duck bill for your 4200 or TAN7350 applicator. Step-by-step guidance using genuine parts to keep your spray tan equipment running smoothly.

When to Replace the Pressure Tube and Duck Bill

The Fuji 5135-5 Pressure Tube and Duck Bill is a small but important part of your Fuji 4200 or TAN7350 spray tan applicator. Over time, the duck bill valve can wear out, allowing solution to back up into the pressure tube. If you notice inconsistent spray or solution leaking near the cup lid, it is likely time for a replacement.

This 5-pack gives you spares so you can swap the part quickly and keep your equipment in reliable working order.

What the Duck Bill Does

The duck bill sits under the cup lid and acts as a one-way valve. Its job is to prevent spray tan solution from entering the pressure tube. When functioning correctly, it allows air to pass in one direction only. A worn duck bill can lead to solution backing up, which affects spray quality and can cause mess or downtime during a tanning session.

How to Replace the Fuji 5135-5 Pressure Tube and Duck Bill

Replacement is straightforward and takes only a few minutes. Always use genuine Fuji parts to maintain compatibility and performance.

  1. 1. Remove the cup lid: Unscrew or lift the cup lid from your 4200 or TAN7350 applicator. Set it aside on a clean surface.
  2. 2. Take out the old duck bill and pressure tube: Gently pull the old duck bill out from under the lid. Detach the pressure tube from its connection point. Inspect the tube for any cracks or buildup.
  3. 3. Install the new duck bill: Place the new duck bill from the Fuji 5135-5 5-pack into the slot under the cup lid. Ensure it is seated firmly so it forms a proper seal.
  4. 4. Attach the new pressure tube: Connect the new pressure tube to the duck bill and to the applicator's internal fitting. Make sure the connection is snug but not overtightened.
  5. 5. Reassemble and test: Replace the cup lid and run a brief test spray with water or solution to confirm there are no leaks and the spray pattern is consistent.

Product Evidence for This Replacement

  • Fuji 5135-5 Pressure Tube and Duck Bill: The Fuji 5135-5 Pressure Tube and Duck Bill is for the 4200 and TAN7350 Applicator (5 pack). Confirms compatibility with the two most common Fuji spray tan applicators, so you order the correct part.
    Fuji 5135-5 Pressure Tube and Duck Bill
    Fuji 5135-5 Pressure Tube and Duck Bill
  • Fuji 5135-5 Pressure Tube and Duck Bill: The duck bill replaces the external check valve and prevents solution from entering the pressure tube. This is the core function that keeps your spray equipment working without clogs or backflow.
  • Fuji 5135-5 Pressure Tube and Duck Bill: Sun Tanning Store is an authorized Fuji Spray Tan Distributor and includes the full manufacturer warranty. Buying from an authorized source ensures you receive genuine parts backed by warranty and support.

What to Check Before Ordering

Before purchasing the Fuji 5135-5, confirm your applicator model. This part is designed specifically for the Fuji 4200 and TAN7350. If you use a different model, check the manufacturer documentation or contact support to find the correct replacement part.

The 5-pack gives you extras to keep on hand, which is useful for busy tanning businesses that perform frequent replacements.

Articles connexes

Customer Service
Accueil
Produits
Panier
Profil