How to Set Up Your ProSun Onyx Hybrid Tanning Bed

Quick Answer

Set up your ProSun Onyx hybrid tanning bed by preparing the room, assembling the frame, connecting power, and testing the red light and UV lamps. Follow these steps to avoid common mistakes.

Step-by-Step Setup Process

1. Prepare the Room and Electrical Supply: Ensure the room has a dedicated 20-amp circuit and proper ventilation. The hybrid bed's red light module draws additional power; do not share the circuit with other high-draw equipment. Clear the area of debris and allow at least 2 feet of clearance around the bed for airflow. Check your breaker panel before unboxing. A tripped breaker mid-setup is a common frustration.
2. Unbox and Inspect Components: Carefully open the shipping crate and remove all parts. Verify you have the main canopy, bench base, acrylic sheet, lamp holders, and the red light module. Inspect for shipping damage—especially the acrylic and lamp ends. Report any issues immediately to your supplier. Take photos of the packaging and components before assembly. This protects your warranty claim if damage is discovered later.
3. Assemble the Bench and Canopy Frame: Attach the bench legs to the base using the provided bolts. Then lift the canopy onto the bench hinges. Do not fully tighten all bolts until the canopy is aligned. Use a level to ensure the bench is flat—this prevents uneven tanning and acrylic stress. A common mistake is over-tightening bolts before alignment, which can crack the acrylic or strip threads. Tighten in stages.
4. Install Lamps and Red Light Module: Insert the UV lamps into their holders, ensuring each lamp is fully seated and the clips are secure. Then install the red light LED module according to the manual—typically mounted along the canopy edges. Connect all lamp wires to the ballast, matching the color codes. Wear gloves when handling lamps. Oils from your skin can cause hot spots and shorten lamp life.
5. Connect Power and Test the System: Plug the bed into the dedicated outlet. Turn on the main power switch, then activate the red light mode separately (if your model has a selector). Verify that all UV lamps glow evenly and the red light LEDs illuminate. Listen for unusual buzzing or flickering, which may indicate a loose connection. Run the bed for a full 15-minute cycle without a user to confirm consistent performance. If the red light flickers, check the module's power connector.

Product Facts

• ProSun Onyx 15 Minute Level 3 Hybrid Commercial Tanning Bed With Red Light: The ProSun Onyx 15 Minute Level 3 Hybrid Commercial Tanning Bed integrates 635nm red light alongside powerful UV technology. Red light therapy requires stable power and proper lamp alignment to deliver consistent results, so careful setup is essential.